ACER ASPIRE TC-120 REALTEK LAN DRIVER DETAILS:
|File Size:||2.3 MB|
|Supported systems:||Windows 10, 8.1, 8, 7, 2008, Vista, 2003, XP|
|Price:||Free* (*Free Registration Required)|
ACER ASPIRE TC-120 REALTEK LAN DRIVER
During the disassembly process, group the screws with the corresponding components to avoid mismatch when putting back the components.
Kopioida Acer Aspire Tc 120 Realtek Lan Ajuri V.8.029.0314.2014 Driver Download
Chapter 3 27 Pre-disassembly Procedure Before proceeding with the disassembly procedure, perform the steps listed below: Turn off the system and all the peripherals connected to Acer Aspire TC-120 Realtek LAN. Unplug the power cord from the power outlets. Unplug the power cord from the system. Unplug all peripheral cables from the system. Place the system unit on a flat, stable surface. C60 29 Removing the Side Panel 30 1. Perform the pre-disassembly procedure described on page Remove the two screws A located on the rear edge of the side panel.
Slide the side panel toward the back of the chassis until the tabs on the cover disengage with the slots on the chassis. Lift the side panel away from the system and put it aside for reinstallation later. Chapter 3 Removing the Front Bezel 1.
Remove the side panel. Refer to the previous section for instructions. Remove the front bezel. Release the front bezel retention tabs from the chassis interior. Detach the bezel slightly away from the chassis.
Disconnect the LED cable from the bezel and remove the bezel. For X model, skip this step.
The heat sink becomes very hot when the system is on. NEVER touch the heat sink with any metal or with your hands.
Use a long-nosed screwdriver to loosen the four screws on the heat sink, then Acer Aspire TC-120 Realtek LAN the heat sink fan assembly away from the mainboard. Lay down the heat sink fan assembly, in an upright position, on top of the optical drive, as shown below, then disconnect the fan cable from the mainboard. Remove the heat sink fan assembly from the chassis then lay it down in an upright position—with the thermal patch facing upward.
Acer Aspire TC-120 Drivers Download
Do not let the thermal patch on the heat sink fan assembly touch the work surface. Use an alcohol pad to wipe off the thermal grease from both the heat sink and the processor. Before removing a processor from the mainboard, make sure to create a backup Acer Aspire TC-120 Realtek LAN of all important data. The processor becomes very hot when the system is on.
A 2 Buy or Sell Desktop Computers ⌨️ in Canada Kijiji Classifieds - Page 2
Allow it to cool off first before handling. Release the load lever. Pull the load lever to the fully open, upright position. Pull out the processor from the socket. If you are going to install a new processor, note the arrow on the corner to make sure the processor is properly oriented over the socket.
|ASUS X550LC Realtek Audio||Recent Comments|
|Gigabyte GA-Z77X-UD3H-WB WIFI||for_download_choose_device|
Chapter 3 33 Removing the Optical Drive 1. Disconnect the data and power cables from the optical drive. Disconnect the data and power cables from the HDD.
Place the bracket on a clean, static-free work surface. Chapter 3 35 7. Chapter 3 Removing the Hard Disk Drive 1. Slide the HDD out of the bracket. Free Download Acer Aspire TC Realtek LAN Driver for Windows 10 bit (Network Card). Aspire TC.
What can I do if I am unable to connect via WiFi after completing an Acer Android How can I improve a weak signal to my wireless network?