LEADTEK TV TUNER WINFAST TV USB II WINDOWS 7 64 DRIVER

Leadtek WinFast TV USB II Deluxe Drivers

This fix is from discussions here http: This fix is from http: If you have a quick look inside the file LEADTEK Tv Tuner WinFast TV USB II out of interestyou will notice that how this bug was messing up all the tuner frequency calculations. The frequencies are given in Table 41 in the datasheet http: If not, double check the process, check for errors that might have been missed, and if it all fails, post to a forum. Fix for the 5. However there is a patch missing which enables support: This is based on the following commit: The previous firmware version is more stable. To use the previous version replace the "wget" line in step 5 with: Still only 1 tuner working.

LEADTEK Tv Tuner WinFast TV USB II Driver driver - Driversorg

Second tuner only works on rare occassions. Losing 1 tuner [Comments added by Cloggy - 30 Jun - based on Mythbuntu After a while it would lose that tuner and the only way to get it to work again was to cold boot.

This seems to be caused by power management on the USB bus. Disabling the power management on the USB bus fixed this problem. Similar problem is described here for a Haupage card: Curiously, the power supply in my machine failed a Dell OptiPlex - Small Form Factor and I connected the machine up to a bigger power supply from another machine.

The second tuner has been fine for 4 weeks now without a single reboot. Power cycling by using the power button isn't enough in some cases to bring the malfunctioning DS to a true cold boot state. To do a true cold boot to replicate the act of pulling out a USB device make sure the mains power cord is removed - some PSUs have a rocker switch that will do the same job - and wait about seconds for the 5V bus to shut down completely before reapplying power.

Help Me!!!!!! How too install tv tuner Winfast Usb II Delux in Lucid Lynx.

This was the only way I could get a pair of recently unresponsive DS cards to start working again - the ATX power button cycling wasn't enough. Remote Control Support I Gregoryo have had no success with the remote, but there is hope from dmesg: I have tried using evtest, mode2, and irw to no avail.

I get no indication of any signal coming from the remote. Am I missing a kernel driver module? If you have a quick look inside the file just out of interestyou will notice that how this bug was messing up all the tuner frequency calculations.

The frequencies are given in Table 41 in the datasheet http: If not, double check the process, check for errors that might have been missed, and if it all fails, post to a forum. Fix for the 5. However there is a patch missing which enables support: This is based on the following commit: The previous firmware version is more stable.

To use the previous version replace LEADTEK Tv Tuner WinFast TV USB II "wget" line in step 5 with: Still only 1 tuner working. Second tuner only works on rare occassions. Losing 1 tuner [Comments added by Cloggy - 30 Jun - based on Mythbuntu After a while it would lose that tuner and the only way to get it to work again was to cold boot.

This seems to be caused by power management on the USB bus. Leadtek WinFast TV USB II - TV tuner / video capture adapter - USB overview and full product specs on CNET. This package provides the installation files for LEADTEK Tv Tuner WinFast TV USB II Driver version